Shapes On Tinkercad Activity

Smiley Face Emoji

1. search the cylinder in the geometric section 

2. flatten it to a height of 3mm, the width is 43mm and the length is 38mm  

3. Then click the sphere and placed two spheres as eyes

4. After click the hole option, (top right corner)

5. Then click the half sphere and place it below the eyes

6.  click the hole option to make it a hole

7.  click on the box and make it to a length of 17.08mm, width of 6.28mm and height of 5,71mm

8.  click on the cylinder and flatten it to a height of 3mm, width of 31mm and length of 45mm

9, Go on 'letters' option and click the letters 'h' and 'i', which obviously spell 'hi' 

10. Find the exclamation mark and place it next to the letters. 

Snowman:

1- Search the sphere in the geometric section and place in on the workplane

2- The first sphere is of a length of 24mm, width of 26mm and height of 20mm

3- The second sphere is of a length of 19mm, width of 19mm and a height of 20mm

4- The last sphere is of a length of 16mm, width 16mm and a height of 17mm 

5- and your done with your snowman

House:

1-.Go on 'shape generators' and on 'geometric' 

2-. search for the red box and click on it

3- change the length to 20mm and width 20mm as well as the height to 20mm

4-. Than change the colour of the box to any of the following colours listed

5.- After that search in the geometric section for the roof 

6- change the length to 20mm and width 20mm as well as the height to 10mm

7- To make the door, click again for the red box but made it smaller to fit the house (height of 13mm, length of 9mm and width of 3mm) 

8-. To make the chimney get another red box but sized it to a height of 14mm, width of 8mm and length 7mm and placed it on top of the roof

9-. To create the smoke,Search the sphere in the geometric section and make it small so it could fit the chimney. 

10-. Find the correct size of the shape and then just copy and paste the sphere to make many of the smokes around and on-top of each other